Technical Specifications - Beurer IH 58 Mode D'emploi

Problem/ Possible cause/remedy
question
The atomiser 4. Unsuitable medication fluid added
produces no for nebulisation (e.g. too viscous).
or too little The medication fluid should be pre-
aerosol. scribed by the doctor.
The output is Kinked hose, clogged filter, too much
too low. inhalation solution.
What med- Please consult your doctor in rela-
ications are tion to this matter.
suitable for As a rule, all medication that is
inhaling? suitable and approved for device
inhalation can be inhaled.
There is inha- This is normal and is due to technical
lation solution reasons. Stop inhalation once the
residue in the atomiser starts to make a notably
atomiser. different sound.
What should 1. On infants and children, the mask
be taken into should cover the mouth and nose
account when to ensure effective inhalation.
using the
2. On children, the mask should also
device with
cover both the nose and mouth.
infants and
It is not a good idea to carry out
children?
nebulisation on someone who
is sleeping, as in this case not
enough of the medication will
reach the lungs.
Note: Inhalation should only be car-
ried out under the supervision of an
adult and with their assistance and
the child should not be left alone.
Inhalation us- This is due to technical reasons. You
ing the mask breathe less medication per breath
takes longer. through the holes of the mask than
via the mouthpiece. The aerosol is
mixed with ambient air via the holes.
Problem/ Possible cause/remedy
question
Why should There are two reasons for this:
the atomiser 1. To ensure a therapeutically effec-
be replaced
regularly?
2. Regularly changing the atomiser
Should each Yes, this is absolutely essential for
person have hygiene reasons.
their own
atomiser?

11. Technical specifications

Type IH 58
Dimensions
(W x H x D) 110 x 62 x 47 mm
Weight
176 g
Operating
pressure Approx. 0.25 to 0.5 bar
Atomiser filling Min. 2 ml
volume Max. 6 ml
Medication
flow rate Approx. 0.25 ml/min.
Sound pressure Max. 45 dBA
(acc. to DIN EN 13544-1 section 26)
Mains connection Input: 100 – 240 V~; 50 – 60 Hz; 0.5 A
Output: 5 V
Expected
400 h
service life
Operating Temperature: +10 °C to +40 °C
conditions Relative humidity: 10% to 95%
Ambient pressure: 700 – 1060 hPa
22
tive particle spectrum, the nozzle
hole must not exceed a specific
diameter. Due to mechanical and
thermal stresses, the plastic is
subject to a certain degree of
wear. The atomiser insert [9] is
particularly sensitive. This can also
alter the composition of the aero-
sol droplets, which directly affects
the effectiveness of the treatment.
is also recommended for hygiene
reasons.
; 2 A