Whirlpool WHAP13HAW Mode D'emploi page 6

Assemble Vent Hose
1.
Assemble vent hose
Vent hose
Round
connector
Extend both ends of the vent hose a little bit.
Thread a round connector clockwise onto one end of the vent
hose. Thread a window connector clockwise onto the other end
of the vent hose.
2.
Attach vent hose to air conditioner
Slide the the round end of the vent hose into the hose port on the
air conditoner.
3.
Lock vent hose in place
Turn the locking knob to the LOCKED position to secure the vent
hose in place.
6
95111_WHAP13HAW_portable.indb 6
4.
Attach vent hose to slider panel
Window
connector
Position the air conditioner in the desired location.
Extend the vent hose enough to reach from the air conditoner
to the window. Be sure there are no sharp bends or kinks in the
hose.
Press the window connector end of the vent hose into the
opening on the slider panel as shown. It will clip into place.
Drain Hose Connection (optional)
When using the air conditioner for dehumidification only, you may
attach a hose (not included) for water drainage into a floor drain.
The drain fitting uses a standard garden hose connector. The
drain hose must be below the drain port on the back of the air
conditioner.
1.
Remove drain fitting plug
Turn the drain port retainer plug counterclockwise to remove,
then pull out the rubber drain plug.
For future use, store in a safe location.
Slider panel
Window
connector
5/25/16 4:42 PM