Texi TUTU MC 9900 Mode D'emploi page 133

TEXI Tutu operation manual
ZIGZAG STITCH SEWING
Your machine can sew zigzag stitches of various widths and lengths by changing the settings of the stitch width
and stitch length.
Zigzag stitches are very good
for joining two pieces of fabrics,
applique and sewing various
decorative patterns.
SATIN STITCHING
When you sew the satin stitch by shortening the stitch length, attach the satin foot.
FREE ARM SEWING
By simply removing the extension table, machine becomes a free arm machine
making hard to reach areas readily accessible.
OVERCASTING-OVERLOCKING
Press fabric against the guide plate of the overcasting foot so that
needle falls near the edge of seam.
A. (Width=6.5-5.0) is used for preventing ravelling of fabrics.
B. Can sew overcasting and regular stitches at the same time.
Therefore it is convenient for sewing easy to ravel and stretch
fabrics.
CAUTION: Overcasting foot should be used for sewing patterns
06, 15, 16 only and do not change the stitch width narrower than
5.0 It is possible that needle could hit the presser foot and break
when sewing other patterns and width.
USING THE GENERAL PURPOSE FOOT
Place fabric that needle will fall nearest to edge of fabric when
using the General Purpose Foot.
C. For narrower zigzag width
D. Use 06 when sewing easy to ravel or stretch fabrics.
E. You can also cut off the excess material after sewing the inside
of fabric. Be careful not to cut thread when cutting excess
materials.
131