Texi TUTU MC 9900 Mode D'emploi page 130

TEXI Tutu operation manual
THREADING THE TOP THREAD
THREADING THE UPPER THREAD
1. Raise the presser foot lifter.
2. Press the needle up/down and set needle in up position.
3. Pass a spool of thread onto spool pin and set the spool cap.
1 – 6. Thread the machine in the order as illustrated.
THREADING THE NEEDLE EYE
1. Lower the presser foot.
2. Set needle in up position.
3. Lower the threader slowly and draw thread through
thread guide (A) and pull toward the right.
4. Lower the lever as far as it will go. The threader will
turn and the hook pin will go through the needle eye.
5. Draw thread through the lower guide.
6. Hold thread loosely and release the lever. Hook will
turn and pass thread through needle eye while making
a loop.
7. Pull thread out about 10 cm from needle eye
CAUTION: Do not lower the threader lever while
machine is operating.
DRAWING UP THE BOBBIN THREAD
1-2. Raise the presser foot. Hold the upper thread loosely and press needle up/down button twice. The hand
wheel will turn one complete turn.
3. Pull upper thread lightly. Bobbin
thread will come up in a loop.
4. Pull both upper and bobbin threads
about 10 inches toward the back of
presser foot.
128