Texi TUTU MC 9900 Mode D'emploi page 129

TEXI Tutu operation manual
STARTING TO SEW
The machine will be set at 01 automatically to sew straight stitches when power switch is turned on.
1. Check the presser foot (General Purpose Presser Foot).
2. Place the fabric under the presser foot.
3. Lower the presser foot.
4. Hold back both threads when starting machine.
Let threads go after sewing a few stitches.
5. Regulate the speed while sewing.
6. Stop machine when you reach end of seam.
7. Raise the presser foot lifter.
8. When you have reached the end of a seam, stop sewing and turn the
hand wheel toward you to bring the needle to highest position. Raise
the presser foot and pull the fabric out from under the foot to the back
of the machine. Cut the threads in the thread cutter on the left side of
the machine.
REVERSE STITCHING
Reverse stitching is used for reinforcing the ends of the seams
1. Place the fabric in position where back stitching is to be made
and lower the presser foot.
2. Press reverse stitch button and sew 4-5 stitches. (Using foot
controller, press pedal with pressing reverse stitch button.)
3. Press start button and resume sewing. (Using controller,
release reverse stitch to forward stitching.)
4. When you reach the end of seam, press reverse stitch button
and sew 4-5 reverse stitches.
TURNING CORNERS
1. Stop the machine when you reach a corner.
2. Lower needle into the fabric. To lower the needle, you can either
use the needle up/down button or turn the handwheel toward you.
3. Raise the presser foot.
4. Use the needle as a pivot and turn fabric.
5. Lower the presser foot and resume sewing.
CAUTION: While sewing, special care is required around the needle.
The machine will automatically feed the fabric, do not pull nor push fabric. Simply
guide the fabric to sew straight.
127