Publicité
Les langues disponibles
Les langues disponibles
STAND BY
LAMP
TEMP
OPERATE
OPERATE
PC
VIDEO
5
V-KEYSTONE
H-KEYSTONE
VOL.
MENU
EXIT
ENTER
OPERATE
PC
VIDEO
OPERATE
W
DIGITAL
V-KEYSTONE H-KEYSTONE SCREEN
ZOOM
S
FREEZE
VOLUME
FOCUS
QUICK ALIGN.
5
MENU
EXIT
ENTER
PRESET
HIDE
5.
Adjusting the Sound Volume
To increase the volume: press VOLUME
To lower the volume
VOLUME
VOL.
Projector:
Remote Control
Control panel
Unit
Audio-Vol
12
Screen display
Note
• When the sound volume is displayed on the screen, pressing
the PRESET button will reset the set value to "0".
1.
Press the OPERATE button on the projector (or the OP-
ERATE button on the remote control unit ) for 1 second
or more.
The OPERATE indicator will disappear, the STAND BY indicator
starts to blink, and the projector goes into the cool-down mode.
● The STAND BY indicator will continue blinking for approximately
90 seconds as the temperature of the light source lamp cools (Cool
Down Mode).
OPERATE
OPERATE
Projector:
Remote Control
Control Panel
Unit
Note
• The OPERATE button will not work for approximately 1 minute
from when the light-source lamp is turned on. Wait approxi-
mately 1 minute before pressing.
Caution
• Please do not pull out the plug from the power source when
the STAND BY indicator is blinking. It will shorten the life of
the lamp and cause a malfunction.
Basic Operations
(0 ➞ 50)
ª
(50 ➞ 0)
·
: press VOLUME
When "Menu display" (☞ page 39) is
set to "15sec", after pressing the VOL-
UME button, the sound volume display
will appear on the screen for about 15
seconds.
(Press EXIT button to immediately re-
move the Audio-vol display.)
Audio-Vol
Power Off
Turn off
LAMP
TEMP
Projector: Indicator part
Turn on
STAND BY
OPERATE
27
Publicité
