Jonsered LM 2146 CMD Manuel D'utilisation page 11

quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION: Do not use gasoline with an
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
To set the cutting height
Note: Set the same height on all 3 cutting height
adjustment levers.
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height.(Fig. 37 )
CAUTION: Do not set the cutting height too
low. The blades can hit the ground if the
surface of the lawn is not level.
To start the product
• The very first time you start the product, press the
primer bulb 5 times. The next time you start the
product when the engine is cold, press the primer
bulb 3 times.
• Make sure that the ignition cable is connected to the
spark plug.
Manual start (LM 2146 CMD)
1. Stay behind the product.
2. Hold the engine brake handle against the handlebar.
(Fig. 38 )
3. Hold the starter rope handle with your right hand.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
349 - 003 - 24.10.2017
4. Slowly pull out the starter rope until you feel some
resistance.
5. Pull with force to start the engine.
Electrical start (LM 2146 CMDAE)
1. Make sure that the battery is charged. See
charge the battery on page 13 .
2. Attach the battery to the engine.
3. Hold the engine brake handle against the handlebar.
(Fig. 39 )
4. Press and hold the electrical starter button until the
engine starts.(Fig. 40 )
To use the drive on the wheels
• Push the drive bail in the direction of the handlebar.
(Fig. 41 )
• Before you pull the product rearward, disengage the
drive and push the product forward approximately
10cm.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
To stop the product
• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * see instructions in
Safety devices on the product on page 8 .
WARNING: Do not twist the starter rope
around your hand.
To
11