Starting Up - ADE Linette Mode D'emploi

Starting up

Inserting/changing batteries
For use, you need 2 batteries of type LR03 (AAA), 1.5 V (included). The battery
compartment is located on the underside of the device.
1. Push the locking tab towards the edge of the scale and remove the battery
compartment cover.
2. Insert the batteries as indicated at the bottom of the battery compartment.
Pay attention to the correct polarity (+/-).
3. Replace the battery compartment cover. The locking tab must snap audibly into
place.
Suggestions for changing the battery:
‚ A battery change is necessary when "Lo" or nothing at all is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical data".
‚ Always change all batteries at the same time.
‚ Dispose of old batteries in an environmentally appropriate way
(see "Disposal").
‚ Calibrate the scale, see "Setting the scale".
Choosing the unit of measurement
When the scales are delivered, the unit of measurement is set to "kg" as standard.
However, the measurement result can also be displayed in the English unit "lb" (pound)
or "st lb" (stone:pound).
1. To switch on the scale, step on the middle of the weighing surface.
2. Press repeatedly the Unit button on the back of the scale.
Note the display.
Positioning the scales
1. Place the scale on an even, firm and dry surface. Do not place the scales on a carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
Bathroom Scales BE 1906 | BE 1907
Starting up
17