Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Transport to installation site
2
1
3
The appliance is very heavy.
Take maximum care during handling to
avoid injury.
The appliance should always be transport-
ed in an erect position.
Avoid at all costs leaning it on its front side.
Since this is a large and heavy appliance, before transporting the ap-
and unpacking
pliance, check the access to the location where it will be installed
(door size, manoeuvring space in stairwells, etc.).
The appliance is attached to the base of the packaging (pallet)
through four bolts which can be removed using a 17 mm (3/4") wrench.
It is recommended to use a manual transporting device to move the
appliance to the installation site, and only at this point to remove the
base of the packaging.
The appliance should always be transported in an erect position.
If this is not possible, transport the appliance laying on its rear side.
Once at the installation site, the appliance, which is equipped with four
wheels, can be taken off the pallet and positioned in the installation
area.
4
1
Operate as follows:
Take off the four bolts
means of a 17 mm (3/4") wrench or socket.
Remove the fixing brackets
To remove the front fixing bracket
the rear wheel adjusting bolt
do not overtighten the nut as it could damage the leveling feet adjust-
ing system.
From the back of the unit and by means of a suitable, high duty hand
trolley, take off the appliance and place it on the floor. Be mindful of
any debris on the floor which could get caught under the rollers and
potentially damage the flooring when moving the appliance.
Be very careful to avoid any damage to floors. Delicate floors should be
protected with plywood, hard cardboard or similar material panels.
Installation Guide
Preparing the installation
securing the appliance to the pallet by
1
and
.
3
4
, unscrew for one or two turns
3
by means of a 13 mm (1/2") socket,
2
Series: All
7
Publicité
Chapitres
Table des Matières
