Set Unit Parameters - Endress+Hauser mini-log b 507000 3W Manuel De Mise En Service

8. Setting up unit using PC software

8.2 Set unit parameters

Open the window displayed below by operating the command
UNIT, point "Display/change unit settings" or click
Using the mouse cursor select the entry that you have created
under unit identifier. The stored values are read from the unit
and transferred to the PC software.
Using the mouse cursor select the required listed entry
under „Chapter/Matrix" for further information.
The entries can be changed by using a double click on
individual selections.
Once setting up has been completed click „Finished" and save
the new entries.
36