Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna FS400 LV Manuel D'utilisation

Before starting

WARNING! Please read the operator's
!
manual carefully and make sure you
understand the instructions before using the
machine.
Wear personal protective equipment. See
instructions under the heading "Personal
protective equipment".
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury.
• Perform daily maintenance. See instructions in the section
"Maintenance".
• Fill the water tank or connect the machine to a water
supply.
• Mark the cuts to be made.
• Lower the front guide and align the machine with the
marking.
12 –
English

STARTING AND STOPPING

Starting

Start the engine
• Read the operator's manual supplied by the engine
manufacturer.
Start the cutting.
• Open the water tap.
• Run the engine on full throttle.
• Lower the wheel locking control for setting of cutting
depth.
• Wind down the blade to the cutting depth required. Lower
the blade slowly to avoid engine stop.
• Raise the wheel locking control for setting of the cutting
depth.
• Slowly push the machine forwards. Make sure that the
front guide and the blade do not deviate from the marking.

Stopping

Stop the cutting.
• Lower the wheel locking control for setting of cutting
depth. Unwind the blade from the groove.
• Raise the wheel locking control for setting of the cutting
depth.
• Switch off the water tap.
Stop the engine
• Read the operator's manual supplied by the engine
manufacturer.
• Move the power lever to the "STOP" position.