Table des Matières
Publicité
2. STARTING TO SEW
THREADING yOUR MACHINE
Incorrect threading may cause skipped stitches, breaking threads, or other problems.
Thread correctly before test sewing.
Threading must be carried out in the sequence of Lower Looper - Upper Looper - Needle.
Open the front cover and the working table. Raise needle to its highest point by turning
hand wheel towards you, and raise the presser foot.
Before re-threading lower looper, remove thread from needle eye first, then re-thread the
lower looper. This will prevent tangling.
NOTE: Thread tension is released when the presser foot is up.
THREADING LOWER LOOPER
1.
Feed the thread through the thread guide as illustrated.
2.
Pull the thread through tension slot. Holding the thread with your left hand, pull down
with right hand firmly.
3.
Draw the thread through thread guides as illustrated.
4.
Pass the thread through the lower looper eye and hook it around part A as indicated
by the arrow. Pull about 4" (10 cm) of extra thread above the needle plate and behind
the presser foot.
20
Publicité
Table des Matières
