Narrow And Rolled Hem, Picot Stitch - Husqvarna VIKING H CLASS 200S Guide De L'utilisateur

NARROW AND ROLLED HEM, PICOT STITCH

The narrow and rolled edge stitches are ideal for use on light weight fabrics such as
georgette, crepe, crepe de chine, silk etc.
The picot stitch can be used when sewing on fine scarf-like fabrics. These hems are
unsuitable for use on hard or heavy fabrics.
1. Raise the presser foot.
2. Open the front cover and working table.
3. Pull the stitch finger from the needle plate using a screwdriver. Keep it in the front
cover as illustrated or in the accessory bag.
4. Set the machine according to the Setting Chart on page 30.
NOTE:
1. Please use the recommended threads below for ideal seams.
2. When finished, replace the stitch finger in the needle plate. Please make sure it is inserted
completely as illustrated in Fig. 1.
RECOMMENDED THREAD
NARROW OVERLOCK EDGE
with Three Threads
Thread for needle Polyester, Nylon, Silk No. 50-100
Upper looper
Polyester, Nylon, Silk No. 50-100
Bulk nylon (less stretchable)
Lower looper
Illustration
*I: Stitch finger A
*II: Cross section showing proper placement of stitch finger
*III: Narrow hem
*IV: Rolled hem
*V: Picot stitch
36
ROLLED EDGE
with Three Threads with Two Threads
Nylon No. 100
Bulk nylon (less stretchable)