PEUGEOT Energysaw-305DB Manuel D'utilisation page 48

22. Always check the blade for cracks and damage before use. Immediately replace the blade if cracked or damaged.
23. Use only blades designed to operate at speeds of at least 6500 rpm.
24. Only use blades with a bore diameter of 30 mm.
25. Use the blade guard at all times.
26. The lower blade guard must always be in place and operating correctly.
27. Always keep your hands away from the path of the blade.
28. Never reach around or behind the blade.
29. Make sure that the blade is not touching the workpiece before switching it on.
31. Important: After cutting, release the switch and wait for the blade to stop before moving up the saw.
32. The use of accessories that are not recommended by PSP Outillage may lead to injuries.
33. Make sure that the blade comes to a complete stop before you move or clamp the workpiece, change the angle of
the workpiece or change the angle of the blade.
34. Never cut ferrous metals or masonry.
35. Never re-cut small pieces.
36. Ensure that long pieces are appropriately supported on both sides of the table.
37. Never use the mitre saw in a place with flammable liquids or gas.
38. Never use solvents to clean plastic parts. Solvents may dissolve or damage the material. Just wipe plastic parts clean
with a moist cloth.
39. Disconnect the saw from the power supply before maintenance work or changing the blade.
40. After use, disconnect the saw from the power supply and clean it.
41. Make sure that the working area is clean before leaving the machine.
42. If any part of the saw is missing, damaged or faulty or if an electrical part does not work correctly, switch off the
saw and disconnect it from the power socket. Replace the missing, damaged or faulty part before restarting the
saw.
43. Please keep these instructions for future use. Refer to them frequently and use them to inform other users.
48