Level Washer; Installing Coin Slide And Coin Box - Whirlpool CAE2795FQ Instructions D'installation

IMPORTANT: Level washer properly to reduce excess noise
and vibration.
1. Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor.
Place level here
Not Level
The coin slide mechanism, service door lock and key, and coin
box lock and key are not included with some models, but can
be obtained from the usual industry sources.
Remove the service door of the meter case by lifting it up
at the back. Install the money-accepting device. (Refer to
manufacturer's instructions for proper installation.)
A ground connection is needed for the coin slide, which can be
made by connecting the available harness (W10846503) to the
coin slide.
Place level here
LEVEL Not Level

INSTALLING COIN SLIDE AND COIN BOX

Ground
connection
2. Use a 9/16" or 14 mm open-end or adjustable wrench to turn
jam nuts clockwise on feet until they are about 1/2" (13 mm)
from the washer cabinet. Then turn the leveling foot clockwise
to lower the washer or counterclockwise to raise the washer.
Recheck levelness of washer and repeat as needed.
HELPFUL TIP: You may want to prop up front of washer about
4" (102 mm) with a wood block or similar object that will support
weight of washer.
Jam nut
3. When washer is level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts counterclockwise on leveling
feet tightly against washer cabinet.
Jam nut
For washer using coin slides, use the adapter kit supplied with
the washer.
Install a lock and cam on the meter case service door. Install the
coin vault with lock and key in the meter case opening.

LEVEL WASHER

11