Parkside PRM 1300 A1 Traduction Des Instructions D'origine page 25

tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment carefully
and in accordance with the direc-
tions in these instructions. Ensure
sufficient distance between feet
and the rotating blades.
• Do not tilt the equipment when
starting other than if it is neces-
sary to do so when starting up
in long grass. In this event, tilt it
only as far as absolutely neces-
sary and lift it only on the side
facing away from the user In
this case, tilt the equipment by
pressing down the handle bar
such that the front wheels of the
equipment are raised. Always
check that both hands are in the
working position before return-
ing the equipment to the ground.
• Never use the lawnmower with
damaged protective equipment
or protective grating or without
installed protective equipment,
e.g. deflector plates and/or
grass collection equipment.
Keep away from the ejection
hole at all times.
Caution! Danger! The blade
continues to run after switch-
ing off.
There is a risk of injury.
• The equipment is not to be lifted
or transported while the motor
is running. Switch off the equip-
ment if it has to be tilted in tran-
sit, when crossing surfaces other
than grass, and when the equip-
ment is being transported to and
from the surfaces to be mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.
• Do not leave the equipment un-
attended in the workplace.
• Do not work with equipment
that is damaged, incomplete, or
has been modified without the
authorisation of the manufac-
turer. Do not use the equipment
with damaged safety devices or
screens or with missing safety
equipment such as deflection
and/or grass collection devices.
• Do not overload the equipment.
Work only within the speci-
fied power range and do not
change the regulator settings on
the motor. Do not use low-pow-
ered machines for heavy work.
Do not use your equipment for
purposes other than those for
which it is designed.
• Do not use the equipment near
inflammable liquids or gases.
Non-observance will result in a
risk of fire or explosion.
• Do not lift or carry the equip-
ment when the motor is running.
GB IE
25