Publicité
Instruction Leaflet IL040029EN
Effective December 2017
FR0 mounting instructions
Lift the drive out from the carton, remove the packaging
Step 1:
Attach the drive to the mounting plate with four M5X15
Step 2:
screws and four M5 nuts.The opening dimension on the
mounting plate should follow required dimension (refer
to the drive mounting template printed on the outside
carton)
The drive can be mounted vertically or horizontally
according to customer's need.
SCREW:4-M5*15
NUT:4-M5
Vertical mounting
1. EN version FR0 or US version FR0 with EMC kit
Step 3:
1)Input wiring: Run the L1,L2, L3 wires through a
magnetic ring and wind one lap, fix the L1,L2, L3 wires
and magnetic ring with a cable tie, then connect the
L1,L2, L3 wires to input terminals. Connect the input
grounding wire to the bottom metal plate with a M4*10
screw.)
Output wiring: a ttach a L shape EMC grounding plate to
the bottom of drive with two M4*8 flat screws. Connect
the output U, V, W wires to output terminals. Connect
the output grounding wire to the bottom metal plate
with a M4*10 screw. Clamp the output cable shield to
the L shape EMC grounding plate with a small
rectangular EMC grounding plate and two M4*15
screws.
2. US version FR0 without EMC kit, there are no
magnetic ring and EMC grounding plates, but it is
necessary to connect the output cable shield to the
bottom metal surface with a M4*10 screw
SCREW: 2-M4*10
SCREW: 2-M4*8flat
SCREW: 2-M4*15
Output cable
Magnetic ring
Cable tie
Input power wires
Input grounding wire
Note
FR0 is not available till June 2018.
EATON
6
www.eaton.com
FR1 mounting instructions
Step 1:
Step 2:
Horizontal mounting
PowerXL DH1 Series VFD
Screw: Four M5x15
or 3/16 inch
Nut: Four M5
or 3/16 inch
Publicité
