Advanced Features; Disconnecting Your Wi-Fi Network - Honeywell Wi-Fi VisionPRO 8000 Mode D'emploi

Advanced features

Adaptive Intelligent Recovery (residential use only)—Over time, the VisionPRO
thermostat "learns" how long it takes your system to reach the temperature
you want. It turns on the heating or cooling system earlier to make sure you're
comfortable at the time you expect. The thermostat displays "In Recovery" when
it turns the system on early.
Dehumidification Away Mode—Your system can be set to control indoor
climate while your home is vacant during the humid season. Before you leave,
touch MENU, then select
at levels that protect your home and possessions. When you return, touch
to resume normal operation.
Compressor Protection—The thermostat keeps the compressor off for a few
minutes before restarting, to prevent equipment damage. During this "off" time,
the message "Wait" is displayed on screen.
Pre-occupancy Purge (commercial use only)—This feature turns on the fan 1
to 3 hours before each "occupied" time period, to provide a comfortable work
environment when you arrive.

Disconnecting your Wi-Fi network

If you need to disconnect the
thermostat from your Wi-Fi network (for
example, you're replacing your router),
follow these steps:
1 Touch MENU.
2 Select Wi-Fi Setup.
3 Scroll down to select
Network. Select Yes. The thermostat will
display a question to confirm your
selection.
Yes
4 Touch to confirm that you want to
disconnect from the network.
5 The screen will display "Disconnecting
Please Wait."
6 The screen will show "Wi-Fi Disconnected
Successfully." Touch Done. The thermostat
will display the Wi-Fi Setup screen.
33-00066EFS—05
Dehum Away Mode. Temperature and humidity will be kept
Disconnect Wi-Fi
17
®
Cancel
M35368
M35369
M35370
M35371