Black & Decker BD1800JS Mode D'emploi page 6

ENGLISH
Labels on tool
The following pictograms are shown on the tool: :
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.

Do not expose the battery to water.

Do not store in locations where the temperature may

exceed 40 °C.
Charge only at ambient temperatures between 10 °C and

40 °C.
Charge only using the charger provided with the tool.

When disposing of batteries, follow the instructions given

p
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
Use your Black & Decker charger only to charge the

battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.

Have defective cords replaced immediately.

Do not expose the charger to water.

Do not open the charger.

$ Do not probe the charger.

+ The charger is intended for indoor use only.
- Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
y Charging process completed
Charging
6
Electrical safety
#
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-off button
3. Turbo selector
4. Saw blade locking lever
5. Saw blade support roller
6. Saw blade
7. Shoe plate
8. Shoe plate locking knob
9. Saw blade storage compartment
10. Dust extraction adaptor
11. Battery
Fig. A
12. Charger
13. Charger receptacle
14. Charging indicator
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting and removing the battery (fig. B)
To fit the battery (11), line it up with the receptacle on the

tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (15) while

at the same time pulling the battery out of the receptacle.
Fitting the battery cap (fig. C)
Warning! Fit the cap (16) to the battery (11) for transportation
and storage.
Fitting the saw blade (fig. D)
Hold the saw blade (6) as shown, with the teeth facing

forward.
Push the lever (4) downwards.

Insert the shank of the saw blade into the blade holder

(17) as far as it will go.
Release the lever.
