FireWare Fusion 025-012-012 Mode D'emploi Utilisateurs page 27

User Manual
EN
FireWare Fusion
Fixed mounting of the Fusion
You can mount the Fusion holder in a fixed location. This can be done by mounting the holder in the
desired location using screws or the supplied tape. Thoroughly clean the surface if you choose for the
adhesive strip. Allow 72 hours for suturing before clicking the Fusion into the holder.
ATTENTION!
Check if the location and direction are correct before applying the adhesive strip to the mounting
surface. The adhesive strip is extremely difficult to remove. The sticky tape and holder cannot be reused
after removing it from a surface. Sometimes the mounting surface can be damaged when the adhesive
strip is removed.
Fix the fusion on the holder
CAUTION!
Als u audio met veel bastonen en op een hoog volume afspeelt, kan de Fusion op het oppervlak gaan
schuiven als hij niet is bevestigd op de houder. Plaats de Fusion op een zachte ondergrond als hij niet op
de houder is bevestigd om de kans te verkleinen dat de Fusion gaat schuiven.
1. Slide the lock all the way to the left.
2. Place the Fusion on the holder in the position that gives the best sound.
Four modes are available to choose from for optimal speaker orientation.
3. Slide the lock to the right to lock the Fusion on the holder.
Protection rubber
CAUTION!
Always attach the supplied rubber protection to the holder when not in use. This is to prevent possible
injury from the unprotected holder.
Language change or update
For a language change or update email to: info@fireware.nl. We are happy to help!
www.FireWare.nl
Afbeelding 2
FireWare Fusion 25