Colour-Light Therapy (Optional); Spotlight (Optional); Temperature Display (Optional) - Schmidlin JET Mode D'emploi

Colour-light therapy
The colour-light therapy is an underwater power LED
48
that provides the complete colour spectrum. The func-
tion can be set to either constantly change colours or
maintain a single colour.
Press once:
Press twice:
Press for
2 seconds:
When the function is activated (press once) the LED
slowly passes through the complete colour spectrum.
A specific colour can be selected by pressing the
«Stop» function key when the colour appears.
Press once:
e
Press twice:
in the «Direct colour selection» mode
Press once:
Important
Only switch the colour-light power LED on when the tub is full.
The Power LED is very bright. Never look into the beam directly!
The colour-light function is switched off automatically after 20
minutes. The automatic cut-out is a safety function against acciden-
tal operation and possible overheating.
(optional)
switches on the colour light
switches off the colour light
switches over to the «Direct colour
choice» mode
stop at present colour
continue through the colour
spectrum
The colour changes in the following
order every time the key is
pressed: red, yellow, green,
turquoise, blue, violet, white
Spotlight
(optional)
The status display (LED – light-emitting diode) for the
function key «Spotlight» flashes for 0.5 seconds every
8 seconds when the controller is connected to the
mains (= mains voltage present).
Press once:
Press twice:
Important
If a spotlight has been fitted the whirl system is protected against dry
running (TLS) since the spotlight may only be operated when the tub
is full. The spotlight is cooled by the water in the tub so that the seal
does not overheat. The spotlight can be activated once the water in
the tub reaches the TLS sensor (located above the spotlight).
The spotlight is switched off automatically after 20 minutes. The
automatic cut-out is a safety function against accidental operation
and possible overheating.
Temperature display
The temperature display is activated automatically as
soon as the water reaches the sensor. The sensor is
located in the lower part of the bathtub on the inside.
switches on the spotlight
switches off the spotlight
(optional)
49
e