Disinfection Of The Jet Whirl System; Heater (Optional) - Schmidlin JET Mode D'emploi

Disinfection of the JET whirl system

44
The JET whirl system should be disinfected regularly
(especially before using for the first time and if it has
not be used for a longer period of time).
Pay attention to the instructions for use and dosage
on the bottle. Add the disinfectant to a tub filling of at
least 5 cm above the nozzles.
The disinfectant recommended by Schmidlin can be
used for regular disinfection. This is specially matched
to the materials used for the Schmidlin whirl compo-
nents and is available from specialist dealers or
Schmidlin directly.
If bath additives are used, disinfect the tub with fresh
water (filling level 5 cm above the nozzles).
e

Heater (optional)

The optional adjustable heater for the JET whirl system
is a water flow heater.
The temperature is measured by a sensor in the bath-
tub and compared to the set temperature. The heater
will be activated if the set temperature is higher. If the
heater is activated, this is indicated in the status display
(red LED to the top right above the function key). The
heater can only be activated when the JET whirl system
is in operation.
The currently measured temperature (actual tempera-
ture) is always shown by default.
Display of the temperature
Press The display changes from the ac-
briefly once tual (measured) temperature to the
set (pre-set) temperature.
Example:
In this example the measured temperature is
35 °C and the pre-set temperature 37 °C.
Increase the set temperature
Press for 3 sec. The display changes to the set tem-
perature and the value can now be
changed.
Immediately press
briefly once The set temperature increases by
1 °C. Keep pressing until the desi-
red temperature is reached. Tempe-
rature setting range: 30 °C to 45 °C.
Example:
The display switches back to the actual
temperature after 3 seconds.
Reduce the set temperature
Press for 5 sec. The display changes to the set tem-
perature and the value can now be
changed.
Immediately press
briefly once The set temperature decreases by
1 °C. Keep pressing until the desi-
red temperature is reached. Tempe-
rature setting range: 30 °C to 45 °C.
Example:
The display switches back to the actual
temperature after 3 seconds.
45
e