Approved Combinations Of Cutting Attach- Ment, Deflector, Handle And Harness; Mounting The Drive Tube - Stihl FSE 60 Notice D'emploi

English
4 Approved Combinations of Cutting Attachment, Deflector, Han‐
dle and Harness
Cutting Attachment
1
4.1 Approved Combinations
Select correct combination from the table accord‐
ing to the cutting attachment you intend to use.
WARNING
For safety reasons no other combinations are
permitted – risk of accidents.
Only mowing heads (1, 2) may be used on trim‐
mers with a curved drive tube and loop handle.
4.2 Cutting Attachments
4.2.1 Mowing heads
1 STIHL AutoCut C 52
2 STIHL AutoCut C 6‑2
4.3 Deflector
3 Deflector with blade, for mowing heads
4.4 Handle
4 Loop handle
4.5 Harness
5 Shoulder strap may be used
26
4 Approved Combinations of Cutting Attachment, Deflector, Handle and Harness
Deflector
2
Handle
3
5

Mounting the Drive Tube

3
► Pull the protective cap off the drive tube.
► Push the drive tube (1) into the motor hous‐
ing (2) as far as the mark (A), turning the drive
tube back and forth at the same time.
► Tighten down the screw (3) in the housing
firmly.
Harness
4
2
A
0458-282-9621-B
5
1
A