Dell EMC PowerEdge R440 Manuel D'installation Et D'entretien page 17

Figure 10. Back view of the system with 2 risers
Table 12. Back view of the system with 2 risers
Item Ports, panels, or slots
1 Serial port
2 iDRAC9 dedicated network
port
3 Ethernet ports (2)
4 Low profile riser right slot
5 Low profile riser left slot
6 Cabled PSU
7 LOM riser ports (2)
8 USB 3.0 port (2)
9 VGA port
10 System status indicator
cable port
11 System identification button
Icon Description
Use the serial port to connect a serial device to the system. For more
information about the supported serial port, see the
specifications
NA
Use the iDRAC9 dedicated network port to securely access the
embedded iDRAC on a separate management network, see the
Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals
Use the Ethernet ports to connect Local Area Networks (LANs) to the
system. For more information about the supported Ethernet ports, see
the Technical specifications
N/A Use the card slot to connect half-height PCIe expansion card on low
profile riser.
N/A Use the card slot to connect half-height PCIe expansion card on low
profile riser.
N/A For more information about the PSU configurations, see the
Specifications
For more information about the PSU configurations, see the
specifications
Use the USB 3.0 port to connect USB devices to the system. These
ports are 4-pin, USB 3.0-compliant.
Use the VGA port to connect a display to the system. For more
information about the supported VGA port, see the
specifications
N/A Enables you to connect the status indicator cable and view system
status when the CMA is installed.
Press the system ID button:
• To locate a particular system within a rack.
• To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15 seconds.
NOTE:
•
•
Présentation du système Dell EMC PowerEdge R440
section.
section.
section.
section.
section.
To reset iDRAC using system ID, ensure that the system
ID button is enabled in the iDRAC setup.
If the system stops responding during POST, press and
hold the system ID button (for more than five seconds) to
enter the BIOS progress mode.
Technical
Technical
Technical
Technical
17