Avdel 0727 Manuel D'instructions page 57

TAIL JAW ASSEMBLY
■
Unscrew locking ring 20 with special lock ring key* provided with the tool and withdraw the tail jaw cylinder assembly.
■
Noting the orientation of each part, remove seal 19, jaw housing spacer 2, tail jaw housing 10, spring 8 and rubber spring sleeve 4.
■
Using the circlip pliers* remove internal circlip 3.
■
Invert tail jaw cylinder and shake out tail jaws 9.
■
Place the hook on the lock ring key into the jaw slot of the jaw turret and piston assembly 6 and pull out the jaw turret and piston
assembly 6 forward.
■
Remove screw 18 in the back of the jaw turret and piston assembly 6 with an Allen key* while holding the turret with a bar inserted
into the jaw slot of the turret.
■
Clean out the hole in the turret using a 4.7 mm (
■
Replace screw 18 using a suitable non-hardening sealing compound (e.g. Red Hermatite).
■
Clean and inspect tail jaws 9, replacing if worn or damaged.
■
Clean and inspect tail jaw cylinder assembly 7 for scoring of bore, for wear in the circlip groove or clogging of the airways.
■
Clean jaw housing 10, inspect the internal taper for wear and check the vent hole is clear.
■
Check that the free length of the spring 8 is 38.1mm (1.5").
■
Replace rubber spring sleeve 4 if damaged.
■
Grease tail jaws 9, turret and piston assembly 6 and the tail jaw cylinder assembly 7 with Moly Lithium EP3753 grease.
■
Complete assembly in reverse order of dismantling.
BACK-UP RINGS
■
To inspect condition of back-up rings 24, remove the tail jaw cylinder assembly 7 as described above.
■
Slacken socket grub screw 25 in barrel nut 23.
■
Undo the barrel nut 23 using two spanners*.
■
Remove spacer 13 and spacing collar 39 and push barrel 59 forward.
■
Withdraw bush stops 12, back-up ring 24 and buffer 15.
■
When assembling, insert buffer 15, back-up ring 24 and bush stops 12. (It is essential that these parts are assembled in the correct
sequence). On replacement the barrel nut MUST be set with a torque wrench to 15 lbf/ft using the adaptor provided in tool service
kit.
■
Complete assembly in reverse order of dismantling.
TAIL JAW VALVE (SIDE VALVE) - (07271 & 07274 Models)
■
Remove by carefully prising off button 54 and withdrawing spindle 52.
■
Clean and inspect 'O' rings for signs of wear or damage.
■
Lubricate bore of valve with Moly Lithium EP3753 grease.
■
Assemble in reverse order of dismantling.
* refers to items included in the Avdel service kit. For complete list see page 22.
3
/ ") diameter drill.
16
23