Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ATTENTION: press and pull gently to avoid breaking the pla-
stic hook ATTENTION: the front and rear arches are of dif-
ferent sizes. Do not invert them when mounting the fabric
hood.
MOUNTING THE FABRIC HOOD
Open the Taiyo style pack, take the fabric hood and proceed as follows:
7
Insert the front bow into the front channel of the fabric hood by gently sliding
it to the other end
8
Proceed in the same way with the rear tube. ATTENTION: to facilitate the in-
sertion of the rear tube open the zipper of the fabric hood to give less tension.
Remember to close the zipper to facilitate subsequent assembly of the hood.
ASSEMBLY OF STROLLER SEAT FABRIC
With the hood removed from the chassis, proceed as follows:
9
Take the seat and insert the rear fabric part on the frame tubes, passing the
adjustment handle inside the hole. Hook the Velcro. Push the seat down until it
adheres to the backrest
10
Open the Velcro strap under the seat and secure it by pulling it as far as pos-
sible under the seat
11
Lift the footrest by pulling the handle and insert the front part of the seat.
12
Open and hook the fabric with Velcro under the seat to the top tube to keep
the cover well positioned
ATTENTION: all operations from 9 to 12 recommend doing
them without the hood fitted and with the front bar remo-
ved to facilitate assembly
ATTENTION: check that the 5-point belts are all on the front
of the cover and are not caught on the sides of the frame
ASSEMBLING THE COMPLETE HOOD ON TAIYO
13
Gently insert the bows into the joints until you hear a click. ATTENTION: we
recommend first proceeding with the back arch and then with the front arch
14
Open the canopy and tension it
15
For an aesthetic result and optimal tension of the fabric, attach the small
elastic bands to the sides of the fabric hood to the small hooks on the hood joints,
turning them inside to pass in front of the front arch
16
Pull down the fabric ends of the hood for correct assembly
16a
The canopy includes a small sun visor that can be opened at the front
POSITIONING OF THE MATTRESS
17
Place the mattress on the stroller
18
Pass the shoulder straps and the leg divider in the eyelets.
19
The abdominal belt passes to the sides of the mattress. Push the mat firmly
against the backrest for a correct and co m fort position
20
Insert the shoulder covers and the central protection on the belts
USE OF 5-POINT BELTS
21
Insert the shoulder straps into the upper part of the lap belt buckles and se-
cure them
22
Insert the abdominal buckles into the central buckle until you hear a click
23
To release the buckle, press simultaneously as shown in the figure
24
The stroller can welcome the child from the first months of life. Pull the shoulder
14
Publicité
Table des Matières
