Connecting The Nano-Usb Receiver; Power-Saving Mode - SilverCrest SFM 4 A1 Mode D'emploi

Connecting the nano-USB receiver

♦ Remove any other mouse that is connected to your
computer and then restart the computer.
Remove the nano-USB receiver 0 from the storage
♦
compartment 9 on the bottom of the wireless
mouse.
Connect the nano-USB receiver 0 to a free USB-port
♦
on your computer while it is running.
The operating system recognises the new hardware
and automatically installs the necessary drivers. After
the installation of the driver, the wireless mouse is ready
for operation and can be used.

Power-saving mode

The wireless mouse is equipped with a power-saving mode.
If you switch the computer off , the wireless mouse
automatically switches off after around 8 minutes
in order to save power.
If you disconnect the nano-USB receiver 0 from the
computer, the wireless mouse automatically switches
off after around 8 minutes in order to save power.
If you do not click, scroll or move the wireless mouse,
it turns off after about 8 minutes. As soon as you
press any button on the wireless mouse or use the
scroll wheel, the wireless mouse switches back on.
SFM 4 A1
GB
IE
11