Installation - Zanussi ZBF11421SA Notice D'utilisation

Problem
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Temperature cannot be set.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Closing the door
1. Clean the door gaskets.

Installation

WARNING!
Refer to Safety chapters.
www.zanussi.com
Possible cause
Food products are not wrapped
properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The QuickFreeze or QuickChill
function is switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
The QuickFreeze function is
switched on.
There is no cold air circulation in
the appliance.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Location
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a pe-
riod of time.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to
set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Refer to "QuickFreeze function".
Make sure that there is cold air
circulation in the appliance.
"Installation".
gaskets. Contact the Authorised Service
Centre.
Refer to the assembly instructions
for the installation.
Solution
21