Editorial Pictograms; Safety Pictograms; Warnings - Olimpia splendid Sherpa Instructions Pour L'installation

1
IMPORTANT!
To prevent any ris of electric s oc , t e master s itc es must be disconnected before ma ing electrical connections
and carrying out maintenance on t e appliances.
Ma e sure t at all personnel responsible for transport and installation of t e appliance are a are of t ese instructions.
DISPOSAL
The symbol on the product or on the packaging indicates that the product must not be considered as normal domestic refuse but
it must be taken to an appropriate disposal point for recycling electrical and electronic appliances.
Disposing of this product in the appropriate way avoids causing potentially negative consequences both for the environment and
for the health that could occur if the product is not disposed of correctly.
Further information about the recycling of this product can be obtained from your local town hall, your refuse collection service,
or in the store at which you bought the product.
This regulation is valid only in EU member states.
1.2 SYMBOLS
The pictograms shown in the next chapter provide the information necessary for correct use of the appliance in a rapid and
unmistakable way.
1.2.1

Editorial pictograms

Service
• Refers to situations in which you should inform the SERVICE department in the company:
TECHNICAL SUPPORT
Inde
• Paragraphs marked with this symbol contain very important information and recommendations, particularly as regards safety.
Failure to comply with them could result in:
• danger for the operators' safety
• loss of the warranty
• refusal of liability by the manufacturer.
Raised and
• Refers to actions that absolutely must not be performed.
1.2.2

Safety pictograms

Danger of ig voltage
• Signals to personnel that the operation described could cause electric shock if not performed according to safety regulations.
Generic danger
• Signals that the operation described could cause physical injury if not performed according to safety regulations.
Danger from eat
• Signals that if the operation described is not performed strictly according to safety regulations, there is a risk of burns from
contact with very hot components.
1.3

WARNINGS

• The installation must be carried out by the dealer or by other quali ed personnel; if the installation is not carried out correctly,
there may be a risk of water leakage, electric shock or re.
• Install the air-water heat pump following the instructions indicated in this manual; if the installation is not carried out correctly,
there may be a risk of water leakage, electric shock or re.
• It is advisable to use solely the components speci cally designed for the appliance provided; use of other components may
lead to water leakage, electric shock or re.
• Once installation is complete, check there are no refrigerant leaks (if exposed to the ame, the refrigerant produces toxic
gas).
• Upon installation or re-installation of the system, ensure that no substances, such as air, have penetrated the refrigerant circuit
other than the speci ed refrigerant (R410A) (the presence of air or other foreign substances inside the refrigerant circuit may
cause an abnormal pressure increase or system breakdown, with consequent harm to persons).
38