Thermotte; Door And Glass; Warranty; Advice On Lighting A Ire - Nordpeis Q-23FL Manuel D'installation

Thermotte™

The insulation plates (Thermotte - FIG 9) are classi-
ied as "wear and tear" parts which will require to be
exchanged after some years. The wear time will depend
on the individual use of your product.
Nordpeis ofers a one-year warranty on these parts.
After this, replacements can be purchased.
If new plates are needed, contact your dealer.
A. Smoke bale
B. Back plate
C. Front plate
D. Plate under ashbox
E. Side plate left
F. Side plate right
G. Bottom plate left
H. Bottom plate right
Please note: Wood logs that are too long can cause
additional strain and crack the plates, due to the tension
created between the side plates.

Door and Glass

Should there be any soot on the glass it may be
necessary to clean it. Use dedicated glass cleaner,
as other detergents may damage the glass. (NB! Be
careful, even dedicated glass cleaner can damage the
varnish on the door frame and the gaskets). A good
advice for cleaning the glass is to use a damp cloth or
kitchen roll paper and apply some ash from the burn
chamber. Rub around the ash on the glass and inish of
with a piece of clean and damp kitchen roll paper.
NB! Only clean when the glass is cold.
Check regularly that the transition between the glass
and the door is completely tight.
Periodically, it may be necessary to change the gaskets
on the door to ensure that the burn chamber is air tight
and working optimally. These gaskets can be bought as
a set, usually including ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Recycling of the ceramic glass
Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. If mixed with ordinary glass, it would damage
the raw material and could, in worst case end the
recycling of glass. It is an important contribution to the
environment to ensure that ceramic glass does not end
up with the recycling of ordinary glass.
Packaging Recycle
The packaging accompanying the product should be
recycled according to national regulations.

7. Warranty

Use replacement parts recommended only by the
Any unauthorized modiication of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions
see the enclosed warranty card or visit our website
www.nordpeis.com
The CE mark is placed on the side of the insert.

8. Advice on lighting a ire

The best way to light a ire is with the use of lightening
briquettes and dry kindling wood. Newspapers cause a
lot of ash and the ink is damaging for the environment.
Advertising lyers, magazines, milk cartons and similar
are not suitable for lighting a ire. Good air supply is
important at ignition. When the lue is hot the draught
increases and door can be closed.
Warning: NEVER use a lighting fuel such as
petrol, kerosene, alcohol or similar for lighting
a ire. This could cause injury to you as well as
damaging the product.
In order to avoid injuries, please be aware that the
surfaface may become hot during operation and
that extra care need to be taken to avoid skin burn.
Use clean and dry wood with a maximum moisture
content of 20%. The wood should be dried for a
minimum of 6 months after it is cut. Humid wood
requires a lot of air for the combustion, as extra energy/
heat is required for drying the humid wood and the heat
efect is therefore minimal. This in addition creates soot
in the chimney with the risk of creosote and chimney
ire.
GB
Warning!
Manufacturer.
Warning!
Warning:
21