Program Radio - Becker Centronic SunWindControl SWC510 Notice De Montage Et D'utilisation

Caution
•
Ensure that there is optimum radio reception.
•
The thresholds for sun protection and wind monitoring
can be set with the Centronic SunWindControl transmit-
ters.
Put the sensor into programming mode
a) Putting the sensor into programming mode by switching on the
power
Switch on the power.
► The sensor remains in programming mode for 3 minutes.
b) Putting the sensor into programming mode using the programming
button
Press the programming button on the sensor for 3 seconds.
► The sensor remains in programming mode for 3 minutes.
Programming the master transmitter
The master transmitter refers to the very first transmitter
programmed in a receiver. In contrast to subsequently pro-
grammed transmitters, the master transmitter enables,
among other things, the setting of limit positions (for drives
with integrated radio receiver) and the programming or de-
leting of further transmitters. Any transmitter that has separ-
ate UP, STOP, DOWN buttons and a programming button can
be a master transmitter.
If a transmitter is already programmed in the receiver, press
the programming button of the transmitter for 10 seconds.
Press the programming button of the transmitter for 3 seconds whilst in pro-
gramming mode.
► The receiver confirms programming, i.e. the shading solution moves a
few centimetres before reversing the same distance.
The programming process is now complete.
22 - en

Program radio