i-tec C31MYSAFENVME Mode D'emploi page 7

Remark: To ensure correct function of the device, firstly
it is necessary to format the disc. Proceed according
to the below mentioned instructions. As far as the disc
was earlier used, it may not be a necessity. By disc
formatting, you will always lose already saved data. We
recommend that you save important or valuable data in
more than one discs or other data recording media
FORMATTING A NEW HDD
1. Click with the right button on „Desktop".
2. Select „Administrate".
3. Click on „Disc administration".
4. Select HDD with the marking „Unassigned" or
„Uninitialized" and with the specified capacity of
the inserted disc (usually a number lower by same
digit places is displayed).
5. Provided the disc is not initialized, click on the left
field by the right button and select „Initialize disc".
6. Click with the right button on the area of the disc
and select „New simple bunch", click on „Next".
7. Leave the maximum bunch size and click on „Next".
8. Select „Assign a letter of the unit" and click on „Next".
9. Select „Format the bunch with the following
setting" (leave the initial settings). Click on „Next"
and „Finish".
10. HDD will be formatted. The duration of formatting
depends on the HDD size; afterwards the HDD will
be viewable in the system.
PACKAGE CONTENT
• External case for M.2 disc
• USB-C cable (45 cm)
• Screwdriver
• User guide
SAFETY INSTRUCTIONS
• Do not expose to extreme temperatures and air
humidity.
• Use the device on flat surfaces – you will prevent it
from slipping and falling to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the
Manual
| 7
ENGLISH