Abus CASA20550 Manuel Utilisateur page 75

English
rates which WLAN-N provides, your router must also support WLAN-N.
"SSID" (Service Set Identifier) This name identifies the wireless network. The access point and the
WLAN network camera must use the same SSID name. The factory setting is "default". IMPORTANT:
The max. length is 32 characters; do not use: „ , ", <, > and spaces.
"Wireless mode" Select one of the following options:
"Infrastructure" The network camera is connected to the network via an access point.
"Ad-hoc" In this operating mode, the network camera can communicate directly with another network adapter
(network card). A so-called peer-to-peer environment is set up.
"Channel" In infrastructure mode, the channel used is selected automatically by the camera. In ad-hoc mode,
the channel must be set manually in accordance with the other network adapter.
„Force WLAN mode": Select a fixed WLAN mode for your network camera.
"AUTO": Enables autodetection of WLAN mode between camera and router/access point. Depending on
WLAN setting in router/access point (b/g or n mode) the camera will operate in same WLAN mode.
"b/g mode": The network camera set to fixed WLAN mode b/g. Please ensure the WLAN router/access point
is configured to b/g mode as well or at least to auto detection.
"n mode": The network camera set to fixed WLAN mode n. Please ensure the WLAN router/access point is
configured to n mode as well or at least to auto detection.
"Security" Select the encryption method:
"None" No encryption selected.
"WEP" (Wired Equivalent Privacy) A 64- or 128-bit key is used for encryption (HEX or ASCII). To
communicate with other devices, this key must be the same on both devices.
"Auth. mode" Authentication mode: Select one of the following methods:
"Shared" This mode only allows communication with equipment using the same WEP key.
"Open" The key is communicated over the whole network.
"Key length" Select the key length 64 or 128 bits here.
"Key format" Key format
"HEX" Hexadecimal format
"ASCII" ASCII format
"Network key" For different key formats, different key lengths are expected.
64 bits: 10 hex digits or 5 characters
128 bits: 26 hex digits or 13 characters
IMPORTANT: If you wish to use the characters 22 ("), 3C (<) or 3E (>) for the key, you cannot use the
ASCII format.
"WPA-PSK / WPA2-PSK" (Wi-fi Protected Access – Pre-Shared Key) For this method, dynamic keys are
used. As encryption protocols, TKIP (Temporal Key Integrity Protocol) or AES (Advanced Encryption
Standard) can be selected. A so-called Pre-Shared-Key must be assigned as a key.
"Pre-Shared-Key" This key is entered in the ASCII format with a length of between 8 and 63 characters.
75