Use - Unox Pure Mode D'emploi

Final operations
• Open the water fl ow and connect the oven to power supply.
• Turn on the rinse valve
without bubbles. Rinse at least 2 volumes of the empty cartridge that means 11 liters.
Warning: during the rinsing/breathing operation collect in a proper container the water coming
out from the rinse pipe
• Check the system has no leaks.
• Measure the tap water hardness in German degrees with the issued kit following the instruc-
tions attached.

Use

Residual fi ltering capacity (PARAMETER "END")
If, after the setting at work of the fi lter, you need to know the residual fi ltering capacity expressed
in liters proceed as follows:
1. Push button to enter the Programs menu.
2. Push buttons until the display shows "PURE".
3. Push button to enter the Parameters menu.
4. Scroll down the parameters with
5. Push button to display the residual liters of water that the fi lter can treat before
the display shows "WPURE" message that means the need to replace XC216 fi lter.
Note: if the activation code has not been entered the display shows "0"
6. After 5 seconds the display shows again "END".
Note: push button at any time to exit the parameters.
Water hardness (PARAMETER "HRD")
If, after the setting at work of the fi lter, you need to know the water hardness:
1. Push button to enter the Programs menu.
2. Push buttons until the display shows "PURE".
3. Push button to enter the Parameters menu.
4. Scroll down the parameters with
5. Push button to display the water hardness expressed in °dH . Default value is 10 °dH.
6. Set the real value taken with the issued kit if different from the displayed one by
pushing buttons until the display shows the real value.
7. Push button for 5 seconds to store the value; the display shows again "HRD".
English
and rinse the fi ltering system until the fi ltered water fl ows clear and
8
.
9
buttons until the display shows "END".
buttons until the display shows "HRD".
hrd
18
10