Unox Pure Mode D'emploi page 16

First setting at work
ChefTop™and BakerTop™ ovens are able to calculate the total amount of fi ltered water let inside the
oven and give signal when the fi lter needs to be replaced. To let the oven correctly calculate the fi lter
capacity and give the signal when it needs to replace it, set the activation code and the water hardness
level expressed in German degrees (°dH).
Then set following parameters: PIN (activation code), HRD (water hardness) and END (residual fi ltering
capacity) as described here follows:
1. Enter Programs menu by pushing
2. Push buttons until the display shows "PURE".
3. Push button to enter parameters menu.
4. Push the buttons to scroll down parameters menu.
Note: you can exit the parameters menu at any time by pushing
Parameter END: display of the residual fi ltering capacity in liters before the fi lter
replacement
5. Scroll down the parameters with
6. Push button to display the residual liters of water that the fi lter can treat before the display
shows "WPURE" message that means the need to replace XC216 fi lter.
Note: if the activation code has not been entered the display shows "0"
7. After 5 seconds the display shows again "END".
Example 1 – After a few operation hours from the fi rst installation with HRD=10:
Example 2 – At exhausted fi ltering capacity:
English
button.
pure
buttons until the display shows "END".
end
end
button.
16
end
pin
EXIT
hrd
4200
wpure