Unox Pure Mode D'emploi page 17

Parameter PIN: setting of the Activation Number
5. Scroll down the parameters by pushing
6. Push button to display activation number value. Default value is set at 0.
7. Keep the buttons
packaging
8. To store the set value push
Note: in case a parameter different from that one indicated on the fi lter packaging is stored,
the counter-liter function is not activated and "PIN" value is set = "0".
Example – First Installation with PIN=12345:
Parameter HRD: Einstellen des Wertes der Wasserhärte
5. Scroll down the parameters with
6. Push button to display the water hardness expressed in °dH. Default value is 10 °dH.
Set the real value taken with the issued kit if different from the displayed one by
pushing buttons until the display shows the real value.
7. Push button for 5 seconds to store the value; the display shows again "HRD".
Example – Setting HRD=20:
pushed until the display shows the value indicated on the fi lter
button for 5 seconds. The display shows "PIN".
pin
buttons until the display shows "HRD".
hrd
17
buttons until the display shows "PIN" message.
0
5"
1 2 3 4 5
10
5"
20
English