AutoAqua Smart AWC touch SAWC-200P Mode D'emploi page 14

English
2. AWC AUTO Mode (Periodic AWC)
Water change in AUTO mode will perform in two different ways when ATO is off
and on.
When ATO is off, it performs periodic AWC. Users set the timer to decide the water
change interval.* The minimum water change interval is one hour while the
maximum one is 99 days and 23 hours.
the completion of each countdown.
When ATO is on, AWC does not perform in fixed intervals. Users set up timer to
decide how many times AWC is expected to perform in a period. For example, if
users would like to do water change 24 times per day, the timer is set for one hour.
Water change process will be started after the next ATO event.
process will be done as many times in a row as it is delayed. For example, if you
have set AWC every 1 hour and the ATO tops up every 3 hours, then after 3 hours
the ATO will top up and directly afterwards the AWC will perform 3 AWC cycles.
1) Touch to choose AWC AUTO mode.
2) Touch to set the refilling speed if needed.
*Please refer to Refilling Speed Setting.
3) Touch again to enter DAY SETTING of timer.
4) Touch again to enter HOUR SETTING of timer.
5) Touch to start water change cycles.*
*1. It is recommended to do water change in MANUAL mode to estimate the duration of water change
process before doing water change in AUTO mode.
2. The water change interval must be longer than the duration of water change process. If the duration of
water change process is longer than the water change interval, it will trigger 0000 or 1111 alarm, and
the next countdown will not be started. It is recommended for users to extend the interval or shorten the
duration of water change process.
3. When water change is done,
13
Water change process will be started after
flashes for 3 minutes.
Also, water change