Turning Power On/Off - Sharp 8M-B32C1 Manuel D'installation

Caution
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
Off mode, when main power is off.
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
Wait for 15 minutes or more before use to stabilize the image
quality.
INPUT C1 C2 MENU
POWER button
Status
Green lit Power on
Not lit Power off (Standby state*)
Orange lit Input signal waiting state
* Standby mode
Turning Power On/Off
Main power switch
ENTER RETURN
Power LED
Status of the monitor
nOperations after first power-on
Date/time setting
• If the time has yet to be set, the date/time setting screen
appears. Set the date and time.
DATE/TIME SETTING
/ /
01 01 21
/ / 20
OK:[ENTER] CANCEL:[RETURN]
1. Press the or button to select the date and time,
and press the or button to change the numerical
values.
2. Press the ENTER button.
• Be sure to set the date and time.
• The date/time setting screen will close automatically if
no operation is performed for about 15 seconds. The
date and time can be set using DATE/TIME SETTING
from the SETUP menu when the date/time setting screen
disappears.
TIPS
• Set the date in "Day/Month/Year" order.
• Set the time on a 24-hour basis.
• The clock is maintained by the internal battery.
• If you already set the time but the date/time setting
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact an
authorized SHARP servicing dealer or service center for
assistance with battery replacement.
• Estimated service life of the internal battery: About 5
years (depending on monitor operation)
• The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before
its expected operation life.
: :
00 00
:
7
E