Intended Use; Operation; Safety; Charging The Powerbank - Beurer HK 37 To Go Mode D'emploi

• When using a USB mains part, the socket used must always be easily
accessible, so that the USB mains part can be disconnected from
the socket quickly in a hazardous situation. Please also observe the
instructions for use for the USB mains part.
• Risk of explosion! Incorrect handling of batteries can lead to fire,
explosions, leakage of hazardous substances or other hazardous situ­
ations! Do not throw the powerbank into fire, as the integrated battery
could explode.
• Do not disassemble, split or crush the batteries.
• Only use chargers specified in the instructions for use.
• Batteries must be charged correctly prior to use. The instructions
from the manufacturer and the specifications in these instructions for
use regarding correct charging must be observed at all times.
• Always observe the notes on operation (section 4), cleaning and
maintenance (section 5) and storage (section 6).
• If you should have any questions about using our devices, please
contact our Customer Services department.

3. Intended use

IMPORTANT
This heat pad is only designed to warm up the human body.
This heat pad is suitable for personal use only, not for medical or commercial purposes.

4. Operation

4.1 Safety

IMPORTANT
The heat pad is fitted with a SAFETY SWITCH­OFF function. The SAFETY SWITCH­OFF stops the
heat pad overheating by automatically switching it off in the event of a fault. Once the SAFETY
SWITCH­OFF has taken place, the On/Off button (2) on the heat pad and the white LED display on
the powerbank (4) remain illuminated. After cooling, the heat pad switches on again automatically.

4.2 Charging the powerbank

IMPORTANT
Before you begin charging the powerbank (4), please note the information in section 2 "Important
instructions".
The powerbank must be charged fully prior to initial use or if the device has not been used for a long
period. If the powerbank is completely run down, the charging process will take approx. 4.5 hours
until it is fully charged again. To charge the powerbank fully, proceed as follows:
– Insert the charging cable (7) provided into the connection socket of the powerbank.
– Connect the other end of the charging cable to a USB charger via the USB port (USB charger with 5V / 1A
SELV in accordance with the requirements of IEC/EN 60335, not included). Whilst charging, the LED display
on the powerbank flashes white.
13