Installing The Saw Blade; Various Sawing Processes; One-Step Sawing; Two-Step Sawing - B+BTec Diamond 3 405 TS Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DIAMOND3
position and can only be switched on
again after the motor is cooled down . The
switch also protects against power failure .
When the power returns, the motor will not
start on its own but must be switched on
by hand .

Installing the saw blade

WARNING!
Make sure to disconnect the
machine from the power supply
before fitting or switching the
saw blade or when doing any
maintenance on the machine.
• Remove saw cover.
• Block the sawing spindle with the 8
mm Allen wrench .
• Unscrew the hexagon nut with the
wrench and remove the saw flange .
405TS-406TS
®
(Attention: Left-handed screw thread.)
• Clean the saw flanges.
• Fit the saw blade on the centre ring of
the motor flange . (Check the direction
of rotation and make sure the blade is
well centred.)
• Mount saw flange and tighten with
the hexagon nut . Place saw cover and
tighten with the 2 knobs .
7. VARIOUS SAWING
PROCESSES

One-step sawing

(Use only original saw blades as advised
by the manufacturer .)
• Move saw head down until the saw is
appro . 10 mm below the saw table .
• Secure saw head with the knob.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Hold the material with two hands while
making sure your hands are free from
the sawing blade .
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial .

Two-step sawing

• Adjust the saw head in its top position.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop .
• Hold the material with two hands while
making sure your hands are free from
the sawing blade .
• Push the sawing table forward with
controlled feed so that the sawing
blade is easy cutting through the mate-
rial and move the sawing table back-
ward in its initial position .
• Rotate the material and cut it through
19
GB

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Diamond 3 406 ts

Table des Matières