Saw Table; Cooling System; Unpacking And Set Up; Setting Up - B+BTec Diamond 3 405 TS Manuel D'utilisation

GB
on the saw spindle with a hexagon nut
to clamp the saw blade . (Attention: Left-
handed screw thread)

Saw table

The saw table is constructed of welded
stainless steel components, equipped with
anti-slip rubber and adjustable side stop.
The saw table is equipped with 4 ball
bearing guide rollers for precise and easy
cutting feed .

Cooling system

The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade . A drain hole, with a plug, is
located in the water container. Mud flaps
prevent most of the water mist and make
sure most water flows back in the water
container .

6. UNPACKING AND SET UP

Setting up

• Unpack the sawing machine and
inspect for any damaged parts .
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs .
• Level the sawing machine by adjusting
the legs in the sockets and make sure
its stable .
DIAMOND3
405TS-406TS
®
• Release the transportation lock.

Saw head

• By loosening the lever the saw head
can be positioned at the desired
height .
Cooling system
ATTENTION!
Operating the water pump with-
out a sufficient supply of water
may result in pump damage.
• Place the plug in the drain of the water
container .
• Fill up the container with water until
the water pump is submerged till the
pumpgrip .

Connecting to power supply

First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm

Motor protection

The motor is equipped with a thermal
safety switch for protection against an
overload . When the motor gets over-
heated, the switch falls back into its initial
18
2 .