Electricity And Safety; Characteristics; Machine Construction; Saw Head - B+BTec Diamond 3 405 TS Manuel D'utilisation

DIAMOND3
Sawing of calcium silicate will
expose quartz dust. For your
safety wear respiritor equipment.
6 The safety label on the machine should
never be removed .
7 Besides the above-mentioned safety
regulations the user should pay atten-
tion to the following items:
• Read the instructions for setting up and
using the machine carefully .
• Check that the power cord is correctly
connected to the power supply .
• Electrical cables may not come in con-
tact with water or spray water .
• Damaged saw blades should be
replaced immediately .

4. ELECTRICITY AND SAFETY

ATTENTION!
On construction sites electrical appliances
should be connected to specially designed
power supplies . Suitable are grounded
main power supplies equipped with an
earthleak switch of max . 30 mA or sepa-
rating transformers. Non-grounded com-
mon household or similar power outlets are
not suited as a power source .
For water cooled sawing machines stricter
safety standards are applicable . Therefore,
for extra safety the machine must be con-
nected according to one of the following
methods:
• Main power supply equipped with
earthleak switch 30 mA
- - - - - - - - - - - - - - - or - - - - - - - - - - - - - - -
• Separating transformer, only 1 machine
may be connected at any given time
- - - - - - - - - - - - - - - or - - - - - - - - - - - - - - -
• With an intermediate cable equipped
with a PRCD safety switch of max .
30 mA .
405TS-406TS
®

5. CHARACTERISTICS

Machine construction

The stainless steel construction contributes
to a stable, rigid and durable sawing
machine . The 4 detachable legs are to be
installed in the leg sockets at the underside
of the water container and fastened with
the knobs .

Saw head

The saw head is constructed of welded
steel components . The height adjustment
of the saw head is kept in balance by a
spring .

Saw cover

The saw cover is a welded steel plate
cap, simple to remove and install for
changing the saw blade by unscrewing 2
knobs .

Saw spindle

The motor flange is mounted on the saw
spindle . The saw flange is to be mounted
17
GB