When Installing The Antenna Inside The Vehicle (On The Dashboard Or Rear Shelf) - Pioneer SPH-DA210 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
When installing the antenna inside the vehicle
(on the dashboard or rear shelf)
WARNING
Do not install the GPS antenna over any sensors or vents on the dashboard of the vehicle, as
doing so may interfere with the proper functioning of such sensors or vents and may compro-
mise the ability of the metal sheet under the GPS antenna to properly and securely affix to
the dashboard.
Affix the metal sheet on the surface as level as possible where the GPS antenna faces the win-
dow. Place the GPS antenna on the metal sheet. (The GPS antenna is fastened with its magnet.)
Notes
• When attaching the metal sheet, do not cut
it into small pieces.
• Some vehicles use window glass that does
not allow signals from GPS satellites to pass
through. On such models, install the GPS
antenna on the outside of the vehicle.
Metal sheet
GPS antenna
Peel off the protective
sheet on the rear.
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.
Note
The metal sheet
contains a strong
adhesive which may
leave a mark on the
surface if it is removed.
Clamps
Use separately sold clamps
to secure the lead where necessary
inside the vehicle.
Chapter
03
19
En

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Sph-da110

Table des Matières