When Installing The Antenna Inside The Vehicle (On The Dashboard Or Rear Shelf); Installing The Microphone; Mounting On The Sun Visor; Installation On The Steering Column - Pioneer AVIC-W8400NEX Manuel D'installation

Masquer les pouces Voir aussi pour AVIC-W8400NEX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

When installing the antenna inside the vehicle (on the dashboard or rear
shelf)
WARNING
Do not install the GPS antenna over any sensors or vents on the dashboard of the vehicle, as
doing so may interfere with the proper functioning of such sensors or vents and may
compromise the ability of the metal sheet under the GPS antenna to properly and securely
affix to the dashboard.
GPS antenna
Metal sheet
Peel off the protective sheet on the rear.
Double-sided tape
Clamps
Use clamps to secure the lead where necessary inside the vehicle.
NOTES
• Affix the metal sheet on the surface as level as possible where the GPS antenna faces the
window.
• Affix the GPS antenna on the metal sheet using the double-sided tape.
• The metal sheet contains a strong adhesive which may leave a mark on the surface if it is
removed.
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass
through. On such models, install the GPS antenna on the outside of the vehicle.
• Install the microphone in a place where
• Be sure to turn off (ACC OFF) the product
• Depending on the vehicle model, the
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.
1
2
Installing the
microphone
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
before connecting the microphone.
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.

Mounting on the sun visor

Fit the microphone lead into the
groove.
Microphone lead
Groove
Attach the microphone clip to the sun
visor.
Microphone clip
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot
recognize the driver's voice if the sun
visor is in the down position.
Installation on the steering
column
1
Detach the microphone base from the
microphone clip by sliding the
microphone base while pressing the
tab.
Tab
Microphone base
2
Mount the microphone on the
steering column.
En
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Avic-w6400nex

Table des Matières