Publicité
Les langues disponibles
Les langues disponibles
the on/off switch (5) in the direction of the
grinding disc (fig. B1).
• To switch off the machine, press the lower part
of the on/off switch (5) (fig. B2). Hold the ma-
chine away from the work piece when turning
it on and off because the wheel disc could
damage the work piece.
• Clamp the work piece firmly or use another me-
thod to ensure that it cannot move while working.
• Check the discs regularly. Worn wheel discs
have a negative effect on the machine's effici-
ency. Change to a new wheel disc in good time.
Deburring (Fig. H)
An angle of inclination of 30
give the best results when deburring. Move
the machine back and forth using light
pressure. This will prevent the work piece
from discolouring or becoming too hot and
will avoid making groves.
Never use abrasive cutting discs for
deburring work!
Cutting (Fig. I)
For cutting, a special protection guard must
be used (not included).
Maintain firm contact with the work piece to
prevent vibration and do not tilt or apply pressure
and when cutting. Use moderate pressure when
working, appropriate to the material that is being
worked on. Do not slow down wheel discs by
applying sideways counter pressure. The direction
in which you want to cut is important. The machine
must always work against the direction of the cut;
so never move the machine in the other direction!
There is the risk that the machine will catch in the
cut causing kickback and that you will lose control.
Hints for optimum use
• Clamp the work piece. Use a clamping device
for small work pieces.
• Hold the machine with both hands.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the wheel disc on the work piece.
• Slowly move the machine along the work piece,
firm ly pressing the wheel disc against the work
piece.
• Do not apply too much pressure on the machine.
WWW.VONROC.COM
Let the machine do the work.
• Switch off the machine and wait for the machine
to come to a complete standstill before putting
the machine down.
5. MAINTENANCE
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
to 40
will
Remove very persistent dirt using a soft cloth moi-
0
0
stened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
EN
13
Publicité
