Function Descriptions; Buzzer; Memory Function; Maintenance Of Your Pool Heat Pump - Waterco Electroheat Ultra Manuel D'installation

Function Descriptions

1. When power to the unit is switched on the controller display will illuminate.
2. Use the UP and DOWN arrow buttons on the keypad to adjust. Adjustable
functions: For users, the current temperature, flash, " " and " " to adjust, press
ON/OFF button to return to the current status. To fully adjust cooling, heating,
automatic temperature, users need to enter cooling, heating and automatic
mode respectively for adjustment.
3. In auto mode, the units operating speed is displayed on screen.
4. Backlight will be illuminated when buttons are pressed. Backlight will be turned
off if button is not pressed in 1 minute.

Buzzer

Under any operation, a buzzer will sound when any button on the keypad is pressed.
When the unit reports a fault the buzzer will be silent and the code will be displayed
on the controller screen.

Memory Function

The heat pump controller should memorise ON / OFF status, operating mode,
parameter and timer settings. When power is connected and the heat pump is
switched on, the unit will start operation based on the settings when power was
switched off previously.

MAINTENANCE OF YOUR POOL HEAT PUMP

Waterco pool heat pumps have been specifically engineered to give you years of
satisfaction and enjoyment in the pool.

Cabinet Cleaning

To clean the plastic surfaces use mild soapy water and a soft clean cloth. Never use
solvents or abrasives.

Cleaning Evaporator

The evaporator at the rear of the unit must be kept clean and un-obstructed in order for
your pool heat pump to have better efficiency and avoid problems which may void your
warranty. The dirt collected in the evaporator can be removed with a gentle water spray
and the use of a soft brush. Be careful not to damage the aluminum fins.

Cleaning drainage holes

The condensate drainage holes in the base of the unit must be kept free of debris. Blocked
drainage holes may cause water to collect in the unit and become stagnant or, interfere
with electrical components and wiring.
Issues caused by blocked drainage holes in the base of the unit are not covered under
warranty.

Units Located In Coastal Locations

Care and maintenance procedures for Waterco Pool Heat Pumps installed in coastal
locations.
Exposure to salt may result in evaporator coil damage shortening the life of the equipment.
Bare aluminium fins can deteriorate rapidly depending on a number of factors including
fin design, location of the equipment relative to salt water, and maintenance.
For Waterco pool heat pumps located within one kilometre from the coast a coating must
be applied to the unit prior to site delivery on the evaporator fins and exposed metal
surfaces to reduce the incidence of corrosion.
A monthly rinse with potable water straight from the garden hose connected to the
municipal water system to remove the salt build up on the evaporator coil and exposed
metal surfaces is necessary.
Pool Heat Pump I pg 22