Inverter Pool Heat Pump Controller; Inverter Controller Operation; Timer Function - Waterco Electroheat Ultra Manuel D'installation

Inverter Pool Heat Pump Controller

This controller applies to DC inverter air source pool heat pumps, for heating.
Heating
Automatic Mode
Clock/ Timer/ Function Display
Clock Adjustment Icon
On Timer Icon
Off Timer Icon
Temperature Display - the numerals on the left side indicate the set
water temperature. The numerals on the right side of the display
indicate the pool water temperature.
Temperature Icon (in degree Celsius)
Function Settings Icon
Keypad button lock is active
Real-time Temperature Distinction Icon
Set Temperature Icon
When heating mode is selected the units operating speed is indicated
as follows - one bar - low speed, two bars - medium speed and three
bars - high speed. The unit also has an AUTO mode where the units
,
heating rate is automatically selected according to the air, set and pool
water temperatures.

Inverter Controller Operation

Button functions are as indicated below:
" " button: Press briefly then release to switch the machine on/off, press 3
seconds to lock or unlock buttons.
" " (Up), " " (Down) buttons: To set temperature, off timer, to increase or
decrease parameters.
" " button: Press briefly then release for on and off timer functions, press 3
seconds to set clock.
" " button: Press briefly then release to set low-auto when set to heat,
intermediate-frequency, high-frequency and auto when set to heat.
" " button: Press 3 seconds to switch between cooling, heating and automatic
mode.

Timer Function

1. A 24hr timer function is included in the units controller which may be set in one
minute increments.
2. On timer function: - When the heat pump is switched off, enter the settings
menu and set the on timer to switch the unit on automatically.
3. Off timer function: - When the heat pump is switched on, enter the settings
menu and set the off timer to switch the unit off automatically.
4. The timer function may repeat and is only deactivated when the ON / OFF
button is selected.
5. Timer error is less than 1min/h.
Note: Timer time is calculated based on Clock time.
Pool Heat Pump I pg 20