Sony VPL-FH300L Guide De Référence Rapide page 34

Symptom
The image extends beyond
the screen.
The picture flickers.
Indicators
Message
The LAMP/COVER
indicator flashes in orange.
(Repetition rate of 2
flashes)
The LAMP/COVER
indicator flashes in orange.
(Repetition rate of 3
flashes)
The LAMP/COVER
indicator flashes in orange.
(Repetition rate of 4
flashes)
ON/STANDBY flashes in
red. (Repetition rate of 2
flashes)
ON/STANDBY flashes in
red. (Repetition rate of 4
flashes)
ON/STANDBY flashes in
red. (Repetition rate of 6
flashes)
LAMP indicator 1 (2)
lights in orange.
The PIC MUTING
indicator lights in orange.
16
GB
Troubleshooting
Cause and Remedy
The APA key has been pressed even though there are black edges
around the image.
c
Display the full image on the screen and press the APA key.
Adjust "Shift" in the Screen menu properly.
"Phase" in the Screen menu has not been adjusted properly.
c
Adjust "Phase" in the Screen menu properly.
Meaning and Remedy
• The lamp cover or the air filter cover is detached.
c
Attach the cover securely.
• The lamp has reached the end of its life.
c
Replace the lamp.
• The lamp has reached a high temperature.
c
Wait for 60 seconds to cool the lamp and then turn on the power
again.
The shutter fails to operate properly.
c
Consult with qualified Sony personnel.
• The internal temperature is unusually high.
c
Check to see that nothing is blocking the ventilation holes.
• The projector is being used at a high altitude.
c
Ensure that "High Altitude Mode" in the Setup menu is set to
"On."
The fan is broken.
c
Consult with qualified Sony personnel.
Unplug the AC power cord from the wall outlet after the ON/
STANDBY indicator goes out, plug the power cord to the wall
outlet, and then turn the projector on again. If the ON/STANDBY
flashes in red and the problem persists, the electrical system has
failed.
c
Consult with qualified Sony personnel.
• The lamp must be replaced.
c
Replace the specified lamp (Lamp 1 or 2).
* The lamp that needs to be replaced lights.
• The lamp temperature has been high.
c
Wait for more than 60 seconds so that the lamp cools, and then
turn on the power again.
* The lamp that has fails to light is shown.
The projector is in muting mode.
c
To cancel it, press the MUTING (PIC) key on the Remote
commander.