Connection To Electric System; Start-Up - Interpump Group TSX Série Mode D'emploi

4.3 - CONNECTION TO ELECTRICAL SYSTEM
1 - Check that the voltage of the electrical system (mains) is the same as indicated on the ID
label of the machine.
2 - Check that the plug complies with local safety regulations, and that it is provided with
ground connection (earth).
3 - Check that the power outlet has a circuit breaker which trips at less than 30mA.
4 - Do not connect other appliances contemporaneously to the same power outlet.
5 - Insert the plug only after checking that the machine switch is in the OFF position.
The TSX cleaners series are supplied without electric plug.
The assembly of the electrical plug must be done in conformity with IEC rule n. 60634 and must
be effected by qualified personnel, respecting following prescriptions:
1- Use a plug which complies with the local safety regulations and which must necessarily be
grounded.
2- Make sure that the cord/plug connection is perfectly sealed and water-tight.
3- Use plugs that conform to the indications on the ID Tag.
WARNING: IN CASE OF POWER FAILURE DURING USE OF THIS MACHINE, TURN
THE MACHINE POWER SWITCH TO THE OFF POSITION FOR SAFETY REASONS.
4.4 - USE OF CORDS
If an extension cord is used, make sure that plug and receptacle are of a water-tight type. In
any case they must be raised from the ground in order to avoid possible contact with water.
USE OF INADEQUATE
EXTENSION CORDS
MAY CAUSE SAFETY

4.5 - START-UP

Before use of this machine it is IMPORTANT to ensure that the inlet filter is clean (please see
maintenance chapter 9.2 suction filter).
1- Open water supply
2- Push ON button
WARNING
HAZARDS
SELECTION TABLE
Extension
Voltage
cord length
230÷240 Up to 20 m
230÷240 From 20 to 50 m
400÷415 Up to 50 m
17
Cord section
mm
2
2,5
4
2,5