Publicité
Les langues disponibles
Les langues disponibles
To continue the setting for 2
nd
selection for 2
time period.
To finish the setting, press button E(+) or F(-) to find "FINSH", then press OK to finish the setting.
Multi time periods could be used for one day. Same time period could be used for multiple days.
NOTE:
For settings under Mode Selection (Secondary Menu) always remember to press button C(OK) to validate the setting.
Maximum 8 time periods could be used for one program. After manual setting for weekly program, the relevant
program has done the manual setting will update the default program setting accordingly.
Restore Factory Defaults
Unplug the appliance for not less than 5 seconds then plug in to restore the factory defaults.
Using the Remote Control
This heater includes a remote control. To operate the appliance using the remote control, the Master
Power Switch (A) must be the "ON" position. All the buttons on remote control are exactly the same
functions as on control panel.
Battery Replacement
1.
For the first time use the protective plastic tab for the battery must be removed.
2.
For remote control battery replacement, use a Lithium Cell CR2025 3V battery.
Important instructions:
1) Turn off the fireplace when it is left unattended.
2) If you do not use the electric fireplace, e.g. during the summer months, disconnect it from the mains.
3) The heater may emit a harmless odor the first time it is used. This smell is normal and is caused by parts inside and
the shell. This odor usually occurs only at the first commissioning and is not a reason for complaint.
nd
time period, press OK to continue. After OK, the screen will return to the interface of day
GB6
Publicité
